Iron and manganese in well water
How official EPA and Washington Department of Health publications describe iron and manganese in drinking water — the aesthetic (secondary) numbers, the clues in color and taste, and, for manganese, the health-advisory figures DOH now publishes for public water systems. Treatment should follow a laboratory result. This is not medical advice.
What it can look and taste like
DOH publication 331-286, Color, taste and odor problems in drinking water (revised February 2018), is written for people on public supplies and on private wells. It says a sudden color change can indicate a public-health concern and tells private-well owners to contact the local health agency. On common colors and tastes, it states:
- Brown, red, orange, or yellow water is “usually caused by iron rust.” Galvanized iron, steel, or cast iron pipes, or the water main, can cause rusty water. “While unpleasant and potentially damaging to clothes and fixtures, iron in drinking water is not a human health concern.”
- Black or dark brown water is “often caused by manganese in the water or pipe sediment.” If it does not clear after flushing cold faucets and toilets, the publication says to wait about an hour and try again; if it still is not clear and you have a private well, you may need a licensed plumber, and you should check with the local health agency.
- A metallic taste may come from iron or copper leaching from pipes; “less common metals, such as zinc and manganese, could also be a problem.” If you are concerned, “have your water analyzed by a certified lab.”
EPA’s private-well testing chart similarly says stained plumbing fixtures or laundry are a reason to test for iron, copper, and manganese. Color alone is not a laboratory result.
Published numbers
EPA’s secondary drinking-water standards — guidelines for nuisance chemicals, not federally enforced primary health standards — list:
- Iron: 0.3 mg/L. Noticeable effects above that level: rusty color, sediment, metallic taste, and reddish or orange staining.
- Manganese: 0.05 mg/L. Noticeable effects: black to brown color, black staining, and a bitter metallic taste.
Those secondary maximum contaminant levels (SMCLs) apply as guidelines for public water systems. They are not a private-well legal limit. DOH publication 331-597, written as guidance for local government, describes iron and manganese as naturally occurring inorganic contaminants that are “non-acute” / “secondary” (aesthetic) concerns, and recommends initial sampling especially where they have previously been found in groundwater.
This page does not invent a separate private-well numeric standard. Use the laboratory result, the published aesthetic numbers, and advice from the local health department to decide whether treatment is only for staining or taste, or whether another contaminant must be addressed first.
Manganese health advice from DOH
For many years, DOH notes, manganese in drinking water was treated mainly as an aesthetic concern. In December 2023 the Office of Drinking Water revised its recommendations for public water systems in publications 331-740 (for customers) and 331-741 (for system managers), citing studies of health effects at high levels. Those publications are written for public-system customers and managers. They are quoted here because they are the state’s current official manganese advice; they are not a new private-well regulation.
DOH’s customer publication states:
- If drinking water is above the secondary level of 0.05 mg/L, contact the water system provider and ask them to install source treatment. (On a private well, there is no water-system provider; the comparable step is to review the result with the local health department and a qualified treatment professional.)
- If the water tests at or above the health advisory level of 0.3 mg/L, “use another source of water, like bottled water, for preparing baby formula for infants and young children.” Adults who drink water above the health-advisory levels “are at a lower risk than infants and children.”
- “Boiling water may increase manganese concentration because it removes only the water, so it is not recommended.”
- “Manganese is not easily absorbed through the skin. There are no known health concerns from bathing, showering, brushing teeth, or washing clothes in water with high levels of manganese.”
- If you have been consuming water with high manganese and have health concerns, talk to your health care provider.
The same publications also list EPA’s 2004 health-advisory figures: 0.3 mg/L as a 10-day advisory for infants under 6 months and as a lifetime advisory for the general population, and 1.0 mg/L as a 10-day advisory for children 6 months and older and for adults. For public water systems, DOH recommends source treatment when source manganese is greater than 0.05 mg/L, a treated-water goal of 0.02 mg/L or less at the entry point to the distribution system, and public notification when distribution levels are 0.3 mg/L or greater. Those operating recommendations are aimed at water systems, not at a mandate for every private well.
Test first
Use a laboratory accredited for the tests you need. Ecology’s Lab Search can be filtered by analyte. Annual coliform and nitrate tests, recommended by DOH for every private well, are a separate question from iron and manganese; a filter aimed at staining is not a substitute for those tests. If a water softener is under consideration, EPA’s private-well chart says to test manganese and iron as well as hardness. See Testing and treating well water and Hardness and softeners.
Treatment after you have results
The right device depends on the form and concentration of iron and manganese, and on the rest of the water chemistry. DOH’s Group B Water System Design Guide (331-467) describes common public-system strategies for iron and manganese removal as oxidation and filtration, ion exchange, and sequestering; that guide is written for small public water systems, not as a product endorsement for a household. 331-740 notes that manganese in source water is often dissolved, and that it can oxidize and precipitate in tanks and pipes, so the mix of dissolved and precipitated manganese can vary from house to house — one reason public-system guidance prefers treatment at the source over relying only on a device at a single tap. After any treatment is installed, follow the manufacturer’s maintenance instructions and re-test to confirm performance. This site does not publish a water-treatment installer roster, because no official statewide roster was found.
Affiliate placeholders (SpringWell and Aquasana)
If a laboratory result shows a treatment need, some households consider whole-house (point-of-entry) or single-tap (point-of-use) equipment. This site intends to use clearly marked affiliate links for SpringWell and Aquasana once tracked referral URLs exist. Those links are not in place yet, and nothing on this page is a finding that a particular product is appropriate for your lab result.
SpringWell Water affiliate link TODO — official program page (for reference, not a tracked link): springwellwater.com/affiliate-program.
Aquasana affiliate link TODO — official program page (for reference, not a tracked link): aquasana.com/affiliate-program.html.
Do not treat those official program pages as shopping or referral links from this site. See the affiliate disclosure for commission language taken from those program pages. This directory will not invent reviews or “best” rankings to sell a filter.
Gaps
- No current official DOH publication written only for private-well iron treatment was found in this pass. 331-286, 331-597, and the EPA secondary standards are used instead, and 331-740 / 331-741 are clearly identified as public-system publications.
- This page does not invent a private-well legal limit or a “typical” filter size.
- Tracked SpringWell and Aquasana affiliate URLs do not yet exist on this site.
Sources
- EPA, Secondary Drinking Water Standards: Guidance for Nuisance Chemicals.
- EPA, Protect Your Home’s Water (private-well testing chart).
- DOH publication 331-286, Color, taste and odor problems in drinking water (revised February 2018).
- DOH publication 331-597, Guidance for Local Government.
- DOH publications 331-740 and 331-741, Manganese in Drinking Water (December 2023).
- DOH publication 331-467, Group B Water System Design Guide (treatment strategies cited only as public-system guidance).